New Buck Corporation 21 - Manual (Page 15)

Ceiling Support Box
Heater Collar
Ceiling
NOTE: See Chimney
Manufacturers Installa-
tion Instructions For In-
stalling Chimney And
Ceiling Trim Plate.
Double Wall Chimney
Connector
Inner Section of Pipe
Outer Section of Pipe
Figure 10
Close Clearance Installation using: (1) 8" Simpson Dura-Vent double wall chimney
connector "Type DVL" and 8" Simpson Dura-Vent 2100 Deg HT. "Type DP" chimney. (2) 8"
Security Type DL double wall connector and 8" Security Type "ASHT" High Temp Chimney.
(3)8" Selkirk Metal Bestos Model "DS" double wall connector- 8" Selkirk Metal Bestos
Model SSII Type HT Chimney System. (4) 8" Metal Fab Type "DW" double wall connector-
8" Metal Fab 2100 HT chimney. (5) 8" Air Jet. (6) Jakes Evans.
Alcove Installation Clearances
Must use 6" Double Wall Connector and 6" Type HT Pipe listed for close clearance reduction
listed in this manual. For minimum clearances see page 14 .
13