Briggs & Stratton Elite 01937 - Manual (Page 13)

SPECIFICATIONS
Rated Pressure . . . . . . . . 2800 pounds square inch (psi)
Flow Rate . . . . . . . . . . . . . . 2.5 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water Supply Temp . . . . . . . . . . . Not to Exceed 100°F
Automatic Cool . . . . . . . . . . . . . . Will cycle when water
Down System
reaches 125°-155°F
Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 lbs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that have
been subjected to operator abuse or negligence.To receive full
value from the warranty, the operator must maintain the
pressure washer as instructed in this manual.
• Some adjustments will need to be made periodically to
properly maintain your pressure washer. Check the spray
gun and spray tips for wear.
• All maintenance in this manual and the engine owner’s
manual should be made at least once each season.
• If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before Each Use
• Check engine oil level.
• Check water inlet screen for damage.
• Check in-line filter for damage.
• Check high pressure hose for leaks.
• Check detergent siphoning tube and filter for damage.
• Check spray gun and nozzle extension for leaks.
• Rinse out garden hose to flush out debris before
connecting to pressure washer.
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the pumps water inlet. Clean it if
the screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it “springs back” into place when you release it. Put
the safety latch in the ON position and test the trigger.You
should not be able to press the trigger.
Check In-Line Filter
Refer to Figure 16 and service the in-line filter if it
becomes clogged, as follows:
1. Detach spray gun and nozzle extension from high
pressure hose. Detach nozzle extension from spray gun
and remove o-ring and screen from nozzle extension.
Flush screen, spray gun, and nozzle extension with
clean water to clear debris.
2800 PSI Pressure Washer
13
Nozzle Extension
Filter Screen
O-ring
Figure 16 — Clean In-Line Filter
• NEVER repair high pressure hose. Replace it.
• Replacement hose rating MUST exceed maximum pressure
rating of unit.
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
WARNING