Save these instructions, Instruction for use, Installation – Bodum MOCCA 1176 USA User Manual

Page 3: Illustration of the appliance

Advertising
background image

– In the case of a fault or malfunction occurring, switch the appliance off; do

not attempt to repair it yourself. Have repairs to the appliance carried out
only by a customer service workshop that is authorised by the manufacturer.
Failure to comply with the above safety notes can compromise the safety of
the appliance.

– Never attempt to exchange the mains cable of the appliance as special tools

are required for this. To ensure continued safety of the appliance, if the cable
needs to be repaired or exchanged, have this carried out exclusively by a
customer service workshop authorised by the manufacturer.

– To disconnect, turn any control to “off ”, then remove plug from the wall.

– Unplug from outlet when not in use and before cleaning. Allow to cool

before putting on or taking of parts, and before cleaning the appliance.
Never immerse the base station or the water container in water: remember
this is an electrical appliance.

– To protect against fire, electric shock and injury to persons do not immerse cord,

plugs, or base station and water container in water or other liquid.

INSTALLATION

• Place the appliance on a stable flat surface which is neither hot nor near a

heat source. The surface must be dry.
Keep the appliance and its mains cable out of reach of children.

• Ensure that the voltage indicated on the rating plate of the appliance agrees

with the mains voltage in your area. Connect the appliance only to a properly
earthed power point with a minimum output of 6A.
(Use a residual current device (RCD) seek the advice of an electrician.)
While the appliance is in use, the mains plug must be accessible in case of an
emergency.
The manufacturer declines any liability for accidents caused by faulty or non-
existing earthing of the appliance.

• If the power point is unsuitable for accommodating the plug of your appliance,

have the power point changed by a licensed electrician.

ILLUSTRATION OF THE APPLIANCE

SAVE THESE INSTRUCTIONS

INSTRUCTION FOR USE

3

A - Lid of the upper body

B - Upper body

C - Riser pipe

D - Disc sieve

E - Seal

F - Coffee funnel

G - MAX. mark

H - 2 Safety valve

I - Water container

J - ON /OFF switch /pilot light

K - Mains cable

L - Base

A

B

C

L

K

J

I

H

G

D

E

F

Advertising