Ba a, For technical support call – Kargo Master Pro IV Aluminum Ladder Rack (90000) User Manual
Page 8

SILIC
ONE
SEAL
ANT
Apply a healthy air tight bead of silicone around every swaged joint to prevent
moisture from leaking into and out of the joint. If this is not done properly, the
inside surface of the tubes can rust and rusty water can leak out. Maintain this
joint seal throughout the life of your rack.
Rusty Joint
(WITHOUT SEALANT)
For TECHNICAL SUPPORT Call:
1.800.343.7486
HOURS: Monday- Friday 8:00 A.M. to 4:30 P.M. (PACIFIC)
®
B
A
A
3"
8
Drill 1st hole in truck bedrail,
through pre-drilled hole in
the footplate, as shown.
NO DRILL clamp-on mounting
Follow instruction that come with
your Stake Pocket T- Bolt Mounting Kit
#31560
TRUCKs’
BEDRAIL
Optional
T-nut
Optional Clamp-On Mount
Rack Mounting Bracket
Footplate Pre-Drilled Holes
When it is not possible to locate a bolt close to the front leg, use our
optional Stake Pocket T- Bolt Kit #31560.
The T-nuts will go into the stake pocket to secure the footplate to bed
rail, along with the hole drilled into the trucks’ bed rail through the
pre-drilled hole in the footplate. Complete instructions come with the
kit.
This plan is the NO DRILL ANYTHING solution.
These clamps allow you to bolt down the footplates to the trucks’ bed
rail without having to drill any holes in your truck or the footplate.
This kit is #31580.
A
PURCHASED SEPARATELY:
PURCHASED SEPARATELY:
OPTION
B
OPTION
PRO 3