Kargo Master Pro II Service Body (70020) - Manual (Page 7)

#1=
#2=
#3=
STEP 5 SRV-BODY 12_1.1
Set rack on the service body, with the "bulkhead angle iron mounting bracket"
centered between the boxes and pushed forward against the bulkhead. Bring the
rack approximately level, and support the rear with clamps, blocks, or forklift. Bolt
the bulkhead mounting bracket to bulkhead using bolts V, flat washers U and lock
nuts R. Push the rack forward in the mounting bracket slots so that the rear leg
mount plates are firmly against the rear of the service body boxes and position the
mounts so that the rack is level and centered. Before drilling holes in the service
body, check to ensure that the CROSS BAR is about 3" higher that the truck cab.
Drill holes with a 3/8" drill bit through the back of the boxes and attach the rear
mounting plates with button head bolts V, flat washers U and lock nuts R.
Bolt the legs (loosely) to mounting plates with bolts P , lock washers O and flat
washers H.
Tighten down ALL bolts except P bolts.
The lock pins ( J) securing the removable rear cross bar (D) will not
slide in and out easily unless the holes are aligned. Move each
rear leg left or right in the slot to ensure proper alignment.
Tighten bolts P.
Tighten down all nuts & bolts and THAT'S IT! You are now ready to use your rack.
P
O
H