Kargo Master Single Drop Down Ladder Rack E-Series/GM (40953) - Manual (Page 4)

Step 2
Attach the handle latch to the rear bow. The rear bow is the one with the black dampener assembly and 2 holes in the
lift arm, which should face the rear of the vehicle. Bolts go through the second row of square holes from end. Use
5/16”x3/4” carriage bolts with flat washers and nylock nuts. The Kargo Master label must face the rear of the vehicle.
Step 3
Attach ladder hooks to ladder pans on 5/16” studs in desired location. Attach ladder stops to coincide with ladder hooks
by removing 3/8”x3/4” bolt and placing stop so the tab on the stop goes into the corresponding slot. The diagram below
shows in the upper position commonly used for step ladders. You can install in the lower position for extension ladders
for a lower load height.