Kasco I-92 Seeder - Manual (Page 3)

Drawing Number Part Number Description Number Required
1 712 12 volt DC motor (new style—4” diameter) 1
1 600 12 volt DC motor (old style—3-1/4” diameter) 1
2 981C Hopper with decals 1
3 796 Lid for Hopper of I-92 1
4 599 Grey-Iron Base 1
5 797 Lid Spring with 3/16” x 1/2” bolt, washer, & nut 1
6 924 Brace Rod Clamps 2
7 934 Brace Rod—5/16” hole in end 2
8 936 Brace Rod—5/8” hole in end 2
10 986 Fan with 5/16” bore 1
11 767 Straight Angle with Plate welded on end 1
12 768 Right “L-Arm” for Front or Rear Mounting 1
13 769 Left “L-Arm” for Front or Rear Mounting 1
14 831 “Herd Sure-Feed” Decal 1
878 Model # Decal—I-92 1
15 756 Pulley for Remote Control 1
16 757 Spring, Stainless Steel—Used under Agitator 1
17 558 Steel Washer—Used on Fan Shaft, under #757 Spring 1
19 504 Seed Gate with Connecting Linkage (Stainless) 1
20 509 Guide for Seed Gate (set of 2) (Stainless) 2 sets
21 516 Capscrew—1/4” x 1/2” with Flatwasher (Stainless) 2
22 792 Control Handle 1
23 510 Round Head Machine Screw—3/16” x 3/8” (Stainless) 4
24 802SI Pivot Plate with Gauge Markings (Stainless) 1
25 803S Opening Gauge used on 802SI (Stainless) 1
26 804 Hex Head Capscrew—3/16” x 1-3/4” with Nut & Washer 1
27 806 Machine Screw—3/16” x 1-3/4” with Nut & Washer 1
28 807 Compression Spring—Used on Handle 1
29 505 Pan Head Machine Screw—1/4” x 1/2” with Jam Nut 1
30 502 Socket Set Screw—1/4” x 3/8”, used on 986 Fan (Stainless) 2
31 754 Electric Wire—14 gauge—12 feet 1
32 755 Heavy Duty Clamp 1
33 794 Switch, Push/Pull 1
34 813 Rheostat, complete with Bracket & Knob (OPTIONAL) 1
37 517 Blocking Plate (OPTIONAL) 1
41 559 Agitator with 5/16” Bore 1
42 410 Hex Head Bolt—1/2” x 1” with Nut & Lockwasher 2
43 410A Hex Head Bolt—1/2” x 1” with Lockwasher 2
44 407 Hex Head Bolt—5/16” x 1” with Nut & Lockwaster 1
45 422 Hex Head Bolt—5/16” x 1-3/4” with Nut
PART DESCRIPTION