Kinetik LMS Spotlight LMS3 - Manual (Page 6)

5
Using the LMS Spotlight 3
1. Ensure that the area to be treated is cleaned before use.
2. Remove the protective cover and press and hold the ON/OFF button for 2
seconds to turn the unit on.
3. Gently place the illumination area on to the spot or pimple (for the most effective
results, the illumination area must touch the skin at all times). Keep the
illumination area in place until the 1 minute treatment cycle has ended. Repeat
for a further 2 cycles.
4. Once the treatment cycle has ended, the unit will automatically switch off. Clean
the illumination area with an alcohol wipe and replace the protective cover. Do
not immerse the unit in water.
2 sec Repeat for
a further
2 cycles
1 min
For best results, do not exceed 3 treatment cycles in the same area in any 1 hour
period. If you have multiple areas to treat, treat each area for 3 minutes then move to
the next affected area.