Kinetik Thermometer NCT1 - Manual (Page 9)

1. Always make sure the probe lens is clean without any damage and the forehead is clean.
2. Power on: Press the ON/MEMORY button (see figure 1).
3. Measuring body temperature on the forehead:
Forehead mode is the default mode. You can see the icon on the screen and hear two beep
sounds (see figure 1). In this mode, you can hold the thermometer 1 to 3 cm from the central
forehead (Fig. 2) and press the "Scan" button. While scanning, you will hear a beep sound, which
indicates the newest measurement is taking place. The time for measurement is approximately
1 second.
Points for attention:
a. Forehead temperature is displayed in oral value. This mode converts the forehead temperature to display its
`ORAL VALUE EQUIVALENT'.
b. Before the measurement, please stay in a stable environment for 5 minutes and avoid exercise or bath for 30mins.
c. Remember to keep the forehead area clean and away from sweat, cosmetics and any scar tissue while taking a
measurement.
4. Measuring surface temperature:
4.1 After power on, press and hold the ON/MEMORY button, then press the “SCAN” button at the same time
for “Infrared thermometer” mode to see the icon on your LCD display. In this mode, you can measure
surface temperatures.
4.2 When you press the “Scan” button, you will get the real time temperature immediately. If you press and hold
the “Scan” button, the measurements will be continuously updated.
4.3 Applications include temperature measurements for water, milk, cloth, skin or other objects.
* Note: This mode shows the actual and unadjusted surface temperature which is different from the body temperature.
5. Power off:
5.1 Device will automatically shut off if left idle for more than 1 minute to extend battery life.
5.2 Manually power off the device by pressing and holding the ON/MEMORY button (Forehead mode only).
Using Your Non-contact Forehead Thermometer
8
Measurement Process:
Figure 1
Figure 2