Three point saddle bend, 3 point saddle bend table, 45° center bend – Klein Tools 56206 User Manual
Page 9: 60° center bend
9
Three Point Saddle Bend:
The three point saddle bend is a variant of the offset bend since it is an offset bend that returns to the
original in-line run after clearing an obstacle. This bend is intended to bridge over obstacles such as
existing conduit or plumbing running perpendicular to the intended conduit installation.
1.
Determine/measure the offset distance necessary to clear the obstacle and how far away the
saddle bend will need to be from the edge of the conduit. Unlike the offset bend you must
measure to the center of the obstacle to bridge over.
2.
Choose the angle that will be used for the center bend. The other two return bends will be 1/2
the center angle chosen. If the center angle is 45°, the two return bends will be 22.5°. Use the
table to calculate the distance between bends and how much shrink is to occur to the conduit
due to the bends.
Example:
As an example, the offset
distance of an obstacle is 2” and the
distance to obstacle’s center point is 20”.
The installation allows for a 45° saddle
bend. Note: The choice of degree is usually
the installer’s choice and most of the time
the installation location will determine what
degree will fit.
3.
Calculate the value needed to place your first mark on the conduit. This number is determined
by the Measured Distance to Center Point of the obstacle plus the Shrink from the 3 Point
Saddle Bend Table that will occur.
(Measured Distance to Center Point) + (Shrink) = Center Mark
Example: 20” + 3/8” = 20-3/8”
3 Point Saddle Bend Table
Degree of
Bend:
45° Center
Bend
22.5° Return Bends
60° Center
Bend
30° Return Bends
Obstruction
Height
Shrink
Amount
Distance off
Center Mark
Shrink
Amount
Distance off
Center Mark
Every inch Add:
3/16”
2-1/2”
1/4”
2”
1”
3/16”
2-1/2”
1/4”
2”
2”
3/8”
5”
1/2”
4”
3”
9/16”
7-1/2”
3/4”
6”
4”
3/4”
10”
1”
8”
5”
15/16”
12-1/2”
1-1/4”
10”
6”
1-1/8”
15”
1-1/2”
12”