BlueAnt Z9i Bluetooth Headset - Manual (Page 10)

BlueAnt
10
Basic Headset Functions
For easy reference, also see the Button/Function Matrix and the Quick Start Guide.
1. Power ON: Press and Hold the MFB for 3 seconds. The solid Blue LED will light up, and if the battery has ample charge
the Blue LED will stay on for up to 5 Seconds. If the battery is low a solid Red LED will be displayed. After powering ON, your
headset will automatically connect to your last used phone if it is in operating range. If this phone is not range, the Z9i will
enter idle mode after 60 seconds. If no phone has yet been Paired, the Z9i will enter into Pairing mode.
2. Power OFF: Press and Hold the MFB for 3 seconds. The Red LED fl ashes three times.
3. Enter Pairing Mode: With the Z9i OFF, Press and Hold the MFB for about 6 seconds until the LED fl ashes Blue. The
Z9i will stay in pairing mode for 2 minutes then will go into idle mode. To re-enter pairing mode, repeat this step. If you had
already paired 5 devices and want to pair again, you will need to RESET the Z9i to enter pairing mode.
4. Make a Call: Dial the number using your phone as normal. Audio will automatically transfer to the headset.
5. To Answer or End a call: Click the MFB once when there is an incoming call.
Click the MFB to end the call.
6. Reject* a call: Press and Hold the MFB for 1 second when there is an incoming call.
7. Redial*: the last call, Press and Hold the Volume Button for about 3 seconds. To cancel Redial, click the MFB
8. Activate Voice Dialing*: While connected to a phone, Press the MFB
once. Voice commands must have been
previously recorded into your phone (see your phones user guide for specifi c instructions).
9. Volume level: Click Volume or Volume during a call to adjust the desired level. Volume changes will be remembered
for the next call. Be sure to use the headset at a comfortable and safe volume level.