L.e.d. saddlebag extensions, Installation – Kuryakyn 7273 L.E.D. SADDLEBAG EXTENSIONS User Manual

Page 4

Advertising
background image

PAGE

4


STEP 19

Install the saddlebag back on the motorcycle.

STEP 20

Repeat Steps 3 through 19 for the left saddlebag.

NOTE:

For ‘10-up FLHX and FLTRX models skip to STEP 23. The included

6-Pin wiring adapter is required for this installation.

NOTE:

For ’93-’96 models, it will be necessary to hardwire the lights,

skip

to

STEP

26.

Kuryakyn recommends the use of dielectric grease on
electrical connections used in the following sections.

Wiring for ‘97 and Later Models with 8-Pin Connector

STEP 21

Remove the seat from the motorcycle and locate the main taillight
harness. PIC 13 Disconnect the wiring harness. Place a small amount of
dielectric grease on the 8-pin connections from the main taillight wiring
harness and plug the 8-Pin wiring adapter into the ends of the main
taillight harness.

NOTE:

If there is a run-turn-brake controller installed, the wiring

adapter needs to be installed upstream (in front) of the

controller. The installation order MUST BE main harness from

front of bike, then the 8-Pin wiring adapter, then the controller,

finally the taillight harness.

STEP 22

Route the wires from the saddlebags under the seat. Use the included
cable ties to secure the wires away from pinch points, extreme heat or
moving parts. Proceed to Step 32.

Secure all wiring away from any moving parts, pinch points
or extreme heat. Kuryakyn WILL NOT warranty any
electrical component that fails due to pinched, crimped,

broken, abraded, melted or frayed wires.

Wiring for ’10 and Later Models with 6-Pin Connector


STEP 23

Remove the left side cover to expose the wiring harness. Locate the

6-Pin taillight harness. PIC 14

STEP 24

Place a small amount of dielectric grease on the 6-pin connections from
the main taillight wiring harness and plug the 6-Pin wiring adapter into
the ends of the main taillight harness.

STEP 25

Remove the seat to provide proper space, and route the adapter wire to

under the seat. Use the included cable ties to secure the harness out of

the way. Proceed to Step 32.


Secure all wiring away from any moving parts, pinch points
or extreme heat. Kuryakyn WILL NOT warranty any
electrical component that fails due to pinched, crimped,

broken, abraded, melted or frayed wires.

Wiring for ’93-’96 Models and Models Needing Hardwiring

STEP 26

On ‘96 and earlier models and any model without 8-Pin main

harness

AMP

connectors:

Cut the two pigtails with the three pin

connectors from the supplied 8-Pin wiring adapter as close to the

connection point as possible. PIC 15 The remaining 8-Pin Connectors

and harness will not be used.

STEP 27

Using wire strippers remove a small amount of insulation from the cut

ends of the wires. Insert the exposed end of each wire into an included insulated male spade

connector and crimp the end. Make sure that the wire is secure in the spade.

L.E.D. SADDLEBAG EXTENSIONS

INSTALLATION

-cont.-

PIC 10

PIC 11

ROUTE HARNESS THROUGH GROOVE IN FILLER

MAKE SURE WIRE HARNESS FITS IN NOTCH

PRESS FILLER IN PLACE

PIC 13

MAIN TAILLIGHT HARNESS

LINE UP
EDGES

HERE

PRESS FILLER
IN PLACE

ATTACH RUBBER BUMPER HERE

PIC 12

PLACE CORD HOLDERS HERE
AND ROUTE HARNESS

Advertising