Zombie windshield trim – Kuryakyn 1198 zombie WINDSHIELD TRIM User Manual
Page 2
Advertising
INSTALLATION
STEP 2
Remove the three Torx head screws that secure the windshield shown in PIC.1. Set these
aside, they will not be used again.
STEP 3
Place the trim in place, lining up the holes in the trim with the holes in the in the
windshield.
STEP 4
Place the 1/4”- 20 x 5/8” SBHCS screw in the center hole without a washer,
do not tighten.
STEP 5
Place the appropriate Knurled Spike Fasteners in the outside holes with
the ¼” flat washers as shown in PIC.2, do not tighten.
STEP 6
Tighten the screws, being careful not to over tighten them, which may
damage the trim.
STEP 7
Place the zombie emblem in place with head facing up as shown in PIC.3.
PAGE
2
zOMBIE WINDShIELD TRIM
INSTALLATION
PIC.3
PIC.2
INSERT kNURLED
SPIkE fASTENER WITh
ThE 1/4” WAShER
Advertising