Kuryakyn 7242 BAHN SPARK PLUG-HEAD BOLT COVERS - Manual (Page 2)

TIPS FOR PROPER CARE:
Your new BAHN product is made out of anodized aluminum. Anodized aluminum requires special at-
tention when cleaning. Some cleaning products or procedures can actually remove the anodized
treatment which will lead to pitting in the aluminum.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and water. Regular cleaning
keeps contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product. Never use steel or brass
wool, wire brushes, polishing wheels, rubbing or polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN product. Many detergents are
alkaline based.
PAGE
2
STEP 2
Refer to PIC 1. Loosely install two of the included Set Screws into each of the Mounting Caps.
Install one of the Mounting Caps on each headbolt. Push down on the Caps to hold them tight
against the headbolts, then tighten the Set Screws securely.
STEP 3 Refer to PIC 2. Determine the Front and Rear Bahn Spark Plug Head
Bolt Covers. The Covers are marked FRONT and REAR on the under-
side.
STEP 4 Refer to PIC 3. Place the Front Bahn Spark Plug Head Bolt Cover
over the front Mounting Caps. Secure the Cover to the Caps with the
included #10 Socket Head Cap Screws; leave the screws loose until
both have been started in their threads.
STEP 5
Holding the Cover centered in the spark plug opening and sitting
level to the head, tighten the Socket Head Cap Screws securely.
STEP 6 Repeat STEPS 4 and 5 for the rear Cover.
NOTE: Disconnecting the spark plug wires may ease in-
stallation.
It is not necessary to remove the Covers when
replacing spark plugs.
BAHN SPARK PLUG-HEAD BOLT COVERS INSTALLATION
Ride On!
It is the end user’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn
will not provide warranty coverage on products or components lost due to im-
proper installation or lack of maintenance. Periodic inspection and mainte-
nance are required on all fasteners.
PIC 2
PIC 3
PIC 1
SECURE MOUNTING CAPS
WITH THE SET SCREWS
SECURE THE COVERS
WITH THE SOCKET
HEAD SCREWS