Kuryakyn 7631 BAHN CRANK COVER ACCENT FOR VICTORY - Manual (Page 2)

PAGE
2
STEP 4
Align the two holes in the BAHN Crank Cover with the threaded holes (PIC 2) in the engine case.
STEP 5 Attach the BAHN Crank Cover to the engine case with the two included M5 screws. PIC 3
NOTE: The lower screw may be difficult to reach with a standard hex wrench. The follow-
ing steps may help you gain access to the lower screw.
Remove the floorboard-assembly screw shown in PIC 4 and 5.
Slide the floorboard-assembly forward or rearward to gain access to the lower M5
screw.
Tighten the lower M5 screw.
Return the footboard back into its original position. Ensure that the floorboard-
assembly screw is installed in the original hole (The floorboard-assembly screw does not
necessarily have to be installed as shown in PIC 4 and 5).
Torque the floorboard screw to 96 inch pounds (in-lbs).
BAHN CRANK COVER ACCENT FOR VICTORY
INSTALLATION
Ride On!
TIPS FOR PROPER CARE:
Your new BAHN product is made out of anodized aluminum. Anodized aluminum requires special atten-
tion when cleaning. Some cleaning products or procedures can actually remove the anodized treatment
which will lead to pitting in the aluminum.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and water. Regular cleaning keeps
contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product. Never use steel or brass wool,
wire brushes, polishing wheels, rubbing or polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN product. Many detergents are
alkaline based.
REMOVE SCREW TO MOVE FLOOR-
BOARD ASSEMBLY
OEM ADHESIVE DOES
NOT NEED TO BE
REMOVED
PIC 2
THREADED
HOLES
PIC 3
M5
SCREWS
REINSTALL SCREW IN THE SAME
HOLE
PIC 4
PIC 5
SLIDE FLOORBOARD
It is the installer’s responsibility to ensure that all of the fasten-
ers (including pre-assembled) are tightened before operation of
the motorcycle. Küryakyn will not issue a warranty on compo-
nents lost due to improper installation. Periodic maintenance may
be required.