Kuryakyn 7687 TAILLIGHT TOP TRIM for VICTORY - Manual (Page 2)

PAGE
2
STEP 3
Wipe the area around the taillight lens (shown in PIC 1) with the in-
cluded alcohol pad. Allow the area to completely dry.
STEP 4 Test fit the Taillight Top Trim. Make any alignment marks with mask-
ing tape or a non-permanent marker.
NOTE:
Ensure that the Top Trim does not contact the bot-
tom of the license plate mount (refer to the yellow
arrows in PIC 2).
It may be necessary to move the license plate
mount up and out of the way.
Remove the license plate.
Loosen the screws (green arrows in PIC 2) and
push up on the mount, then tighten the screws.
Reinstall the license plate.
STEP 5
Rub the adhesive backing with your fingernail to activate the adhe-
sive. Remove the backing.
STEP 6 Attach the Trim to the fender using the reference marks. Hold in place
for one minute, full bonding will occur in 24 hours.
TAILLIGHT TOP TRIM for VICTORY INSTALLATION
Ride On!
PIC 2
LICENSE
PLATE
MOUNT
SCREWS
PIC 1
CLEAN THESE
AREAS