Britax Diplomat P321900 User Manual
Page 14
12
Lower Universal Anchorage System (LUAS) Installation
Figure A illustrates a typical rear-facing LUAS
•
installation.
Verify that your vehicle is equipped with LUAS
•
anchors. If LUAS anchors are not available, you
must use vehicle belt installation methods.
If stored, remove the LCS strap and connectors from
1
the storage slots under the cover. See page 29.
Press and hold one LCS adjuster release button,
2
then pull to extend LCS strap to full length.
Repeat for the remaining LCS connector.
Thread each LCS connector through the adjacent
3
rear-facing belt slot (Fig. B).
The LCS strap must rest behind the child seat buckle
•
strap.
Recline the child seat and place it sideways on
4
the vehicle seat with the front facing you.
Attach the closest LCS connector to the farthest
5
LUAS anchor (Fig. C).
Check that the LCS connector strap is not twisted,
•
and that the LCS connectors are in an upright
position (Fig. D) to ensure proper installation.
Rotate the child seat into the rear-facing
6
position.
Attach the remaining LCS connector to the
7
adjacent LUAS anchor (Fig. D).
NOTE: It may be necessary to switch the LCS
connectors as shown on page 28 if ANY of the following conditions exist :
Installation : Rear-facing
b
D
Top
Release
Button
C
WARNING!
T
his child seat must be in the
recline position when installed rear-facing. See
Recline Adjustment
on page 29.
A
Rear-Facing