Kuryakyn 7626 REAR TRANSMISSION CENTER COVER — VICTORY - Manual (Page 2)

PAGE
2
REAR TRANSMISSION CENTER COVER — VICTORY
-cont.-
INSTALLATION
STEP 2
Refer to PIC 1. On the clutch-side (left) of the engine case, locate the OEM clutch-cable-bracket.
STEP 3 Refer to PIC 2. From the brake-side (right) of the
bike, locate the upper clutch-cable-bracket screw; re-
move the upper screw and set it aside for now, it will
be reused.
STEP 4 Refer to PIC 3. Locate the included Transmission
Cover Bracket in the kit. Position the Cover Bracket
against the cable bracket; align the holes and secure
the Cover Bracket with the screw from
STEP 3
.
Press the bracket down as you tighten the screw.
STEP 5 Refer to PIC 4. Secure the breather hose to the clutch
cable housing with an included Cable Tie. Do not over
tighten the Cable Tie to allow for adjustment of the
hose. Ensure that the hose does not get pulled out of
the rubber crankcase fitting.
STEP 6 On the brake-side (right) of the bike, remove the
screw from the drive belt cover as shown in PIC 5; set
the screw aside, it will be reused later.
NOTE: Ensure that the metal spacer and
rubber bushing remain in the drive
belt cover.
FRONT OF BIKE
VIEW OF THE CLUTCH-SIDE (LEFT) ENGINE CASE
PIC 1
OEM CLUTCH
CABLE BRACKET REMOVE THE UPPER CLUTCH-
CABLE -BRACKET SCREW
FRONT OF BIKE
VIEWED FROM BRAKE-SIDE (RIGHT)
PIC 2
SECURE THE TRANSMISSION
COVER BRACKET WITH THE OEM
SCREW
PRESS
BRACKET
DOWN, THEN
TIGHTEN THE
SCREW
PIC 3 VIEW FROM CLUTCH-SIDE (LEFT)
FRONT OF BIKE
SECURE
BREATHER
HOSE TO
CLUTCH
CABLE
WITH
CABLE TIE
PIC 4
PIC 5
VIEW FROM BRAKE-SIDE (RIGHT)
REMOVE THE SCREW, IT
WILL BE REUSED