Ride on, Driving light bezels for chieftain – Kuryakyn 5622 DRIVING LIGHT BEZELS for CHIEFTAIN User Manual
Page 2
PAGE
2
STEP 4
Position the Right Driving Light Bezel as shown in PIC 3.
Use masking tape and a marker to make alignment marks;
remove the Bezel.
STEP 5
Use your fingernail to rub the adhesive backing; this will
activate the adhesive. Remove and discard the backing.
STEP 6
Using the marks made in
STEP 4
, align the Bezel and press it into place for one minute; full
bonding will occur after 24 hours. Remove and discard the masking tape.
STEP 7
Repeat
STEPS 4 through 6
for the other side.
DRIVING LIGHT BEZELS for CHIEFTAIN
INSTALLATION
PIC 3
MAKE ALIGNMENT MARKS
Ride On!
BRAKE-SIDE (RIGHT)
Ensure proper adhesion of this product. Remove all grease,
oil, bugs, dirt and other debris (including wax and polish)
from the installation area. Küryakyn will not provide warranty
coverage on products or components lost or damaged due to
improper installation.
Do not attempt this installation in temperatures below 50° F.
Proper adhesive bonding ONLY occurs above 50° F.