Kuryakyn 4320 KINETIC FOOTPEGS - Manual (Page 2)

PAGE
2
A FACTORY SERVICE MANUAL WILL BE HELPFUL IN PERFORMING THIS
INSTALLATION. DO NOT ATTEMPT TO PERFORM THIS INSTALLATION IF
YOU ARE NOT CONFIDENT IN YOUR ABILITY TO COMPLETE ALL OF THE
STEPS IN THE PROCEDURE; CONSULT A TRAINED TECHNICIAN.
IMPROPER INSTALLATION COULD RESULT IN SERIOUS INJURY OR
DEATH.
STEP 2 Remove the stock peg from the peg mount. Pay attention to any spacers or washers installed
between the peg mount and the clevis, it may be helpful later. Keep the mounting hardware, it
may be reused.
STEP 3 Install the new peg adapter as per the instructions with the peg adapter. Check that the peg
adapter is installed correctly and the adapter is able to fold upward.
FOOTPEGS MUST BE INSTALLED SO THEY WILL FOLD UPWARD AND
REARWARD IF HIT BY ANY OBJECT. FAILURE TO ADJUST THE FOOTPEGS
TO OPERATE IN THIS MANNER COULD RESULT IN SERIOUS INJURY OR
DEATH.
STEP 4
Position the peg on the peg adapter and loosely tighten the 5/16”-18 socket head cap screw
located on the end of the peg.
STEP 5
Position the footpeg as desired. Using a hex wrench, tighten the 5/16”-18 socket head cap screw
located on the end of the peg. The peg mount will seat itself into the peg and keep it from
rotating.
STEP 6 Tighten all hardware securely. Insert one of the included 5/16” Hot Spots in the end of the
5/16”-18 socket head cap screw in the end of the peg.
STEP 7 Repeat Steps 2 through 6 for the other peg.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
KINETIC FOOTPEGS W/O ADAPTERS
INSTALLATION