Kuryakyn 7159 MULTI-RACK - Manual (Page 3)

PAGE
3
The mounting legs should be secured perpendicularly to the trunk lid
surface. PIC 6
STEP 7
Ensure that the rack is in the correct position, the legs are adjusted to contact the lid
perpendicularly and the spacing between the clamp assemblies is sufficient. With a
non-permanent marker, trace around the mounting legs on the masking tape.
STEP 8
Using a center punch, mark the center of the mounting locations determined in STEP 7.
MEASURE TWICE – DRILL ONCE. Double check all reference marks
on the Trunk Lid BEFORE drilling. Küryakyn will not be responsible
for incidental or consequential damages resulting from this installa-
tion.
Ensure that there is sufficient clearance and that there are no ob-
structions on the underside of the trunk lid BEFORE drilling ANY
holes.
STEP 9
Using a 1/4 inch drill bit, carefully drill through the trunk lid at all four leg locations.
STEP 10 Loosely attach the Multi-Rack to the trunk
lid. Insert the #10-24 x 1 1/8” Socket
Head Cap Screws through the wide flat
washers and rubber washers, through the
trunk lid, 2nd rubber washers, Round Rack
Foot Bases and into the mounting legs.
PIC 7
The two 10-24 x 7/8” Socket Head Cap Screws have been included for use
with the Short Mounting Legs.
In some instances the mounting legs may spin while tightening the 10-24
fasteners. If this occurs, loosen the 10-24 socket heat cap screws in the
CLAMPS until you can remove the rack and the clamps. Insert a flat blade
screwdriver in the slot in the top of the mounting leg to prevent the leg from
spinning while the screw is tightened. Replace clamps and rack and tighten
all hardware.
STEP 11 If you are satisfied with the location and position of the Multi-Rack, tighten all hardware securely.
THE LUGGAGE RACK HAS A 5 POUND LOAD CAPACITY. IT IS UP TO
THE RIDER TO USE THE RACK IN A SAFE AND PROPER MANNER.
OVERLOADING OR USING THE RACK IMPROPERLY MAY RESULT IN
LOSS OF CONTROL, WHICH MAY RESULT IN SEVERE DAMAGE TO
THE MOTORCYCLE AND/OR SERIOUS INJURY OR DEATH TO THE
RIDER AND/OR THEIR PASSENGER. KÜRYAKYN IS NOT RESPONSI-
BLE FOR ANY DAMAGE,LOSS, OR INJURY CAUSED BY EXCEEDING
THE LOAD CAPACITY.
NEVER EXCEED THE MANUFACTURER’S RECOMMENDED GROSS VE-
HICLE WEIGHT. EXCESS LOADING ON THE MOTORCYCLE COULD
CAUSE DAMAGE, LOSS OR INJURY. KÜRYAKYN IS NOT RESPONSI-
BLE FOR ANY DAMAGE, LOSS, OR INJURY CAUSED BY EXCEEDING
THE GROSS VEHICLE WEIGHT LIMITS.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcycle.
Küryakyn will not provide warranty coverage on products or components
lost due to improper installation or lack of maintenance. Periodic inspection
and maintenance are required on all fasteners.
Ride On!
MULTI-RACK
INSTALLATION
PIC 6
MOUNTING LEG
PERPENDICULAR
TO LID
PIC 7
TRUNK LID