Kuryakyn 4082 ERGO III ADJUSTABLE CRUISE MOUNTS WITH PREMIUM MINI BOARDS - Manual (Page 6)

PAGE
6
STEP 25
Test fit the assembly on the Ergo III mount. With the Helix engaged on the cogs of the Ergo III
mount, pull up on the arm to ensure that the Arm assembly will be in the correct position.
STEP 26 Remove the End Cap and install an included Fixed Position Stopper in place of the Spring and
Steel and Brass Bushings. Reinstall the Rotating Arm, Helix (still aligned exactly as shown in PIC
12 or 13).
STEP 27 Insert the 1/2” Screw and Washer (removed in STEP 20) through the Rotating Arm assembly.
Thread it into the Mount. Torque the 1/2” Screw to 30 FT/LBS.
STEP 28 Repeat STEPS 20 through 27 for the other side.
STEP 29 If necessary, make any other adjustments by referring to STEPS 10 through 19.
ERGO III ADJUSTABLE CRUISE MOUNT CARE:
Do not wash with a pressure washer. The water pressure may remove the grease.
Periodic greasing may be necessary to maintain proper function. FIG 1 and 2
ERGO III ADJUSTABLE CRUISE MOUNTS WITH MINI BOARDS
Ride On!
INSTALLATION
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.
CLUTCH-SIDE (LEFT) SHOWN FIG 2
APPLY A LIBERAL AMOUNT OF GREASE
TO THE HELIX, BOTH INSIDE SUR-
FACES OF THE ROTATING ARM AND
THE INSIDE OF THE END CAP
STEEL
BUSHING
BRASS
BUSHING
END CAP
ROTATING ARM
HELIX
1/2” SCREW
WASHER
END CAP
SPRING
FIG 1
IF DISASSEMBLED, RE-TORQUE
1/2” SCREW TO 30 FT/LBS