Kuryakyn 3990 BLACK ERGO III ADJUSTABLE CRUISE MNTS w/ TRIDENT DUALLY PEGS - Manual (Page 2)

PAGE
2
STEP 1
Read and understand all steps in the instructions before starting the installa-
tion. Park the motorcycle on a hard, level surface and turn off the ignition. Put
the motorcycle on its center stand or secure it in a wheel chock. Allow the
engine and exhaust system cool.
ERGO III ADJUSTABLE CRUISE MOUNT INSTALLATION:
STEP 2 Locate the clutch-side (left) Ergo III Adjustable Cruise Mount. Refer to PIC 1. There will be an “L”
on the backside of the Adjustable Arm as shown in PIC 2. The Mounts are side specific, so ensure
that you have the correct Mount before moving on.
STEP 3
Remove the four screws on the underside of the clutch-side Mount. PIC 3. Set the screws within
arms reach of the work area on the clutch-side of the motorcycle.
STEP 4 Loosely install two of the included Set Screws in the bottom clamp-half as shown in PIC 4.
STEP 5 Turn the clamp-half over and position the Adjustable Stop in the bottom clamp-half. PIC 5.
STEP 6 Position the bottom clamp-half under the clutch-side engine guard as shown in PIC 6 and 7 on
PAGE 3 .
BLACK ERGO III ADJUSTABLE CRUISE MNTS w/ TRIDENT DUALLY PEGS
-cont.-
INSTALLATION
YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST SYS-
TEM DURING INSTALLATION. ENSURE THAT THE ENGINE AND EX-
HAUST SYSTEM HAVE FULLY COOLED TO PREVENT INJURY.
NOTE: In the following instructions, left and right may be referred to as “clutch-
side” (left) and “brake-side” (right) for clarity.
PIC 1
CLUTCH-SIDE (LEFT) BRAKE-SIDE (RIGHT)
“L” = LEFT
PIC 2
PIC 2
PIC 3 CLUTCH-SIDE (LEFT)
REMOVE THE FOUR
SCREWS TO SEPARATE
BOTTOM SIDE OF CLAMP
PIC 4
LOOSELY INSTALL TWO OF THE SET
SCREWS IN THE BOTTOM CLAMP-HALF
PIC 5
ADJUSTABLE STOP
REMOVE AND DISCARD THE PAINT PROTECTING
FILM BEFORE INSTALLATION.