Ride on, Saddlebag front kick accents, Installation – Kuryakyn 7692 SADDLEBAG FRONT KICK ACCENTS User Manual
Page 2
PAGE
2
Ensure the area of installation is free of grease, oil,
dirt or other debris including wax/polish products
and bugs to ensure proper adhesion. Küryakyn WILL
NOT issue a warranty on any parts lost due to
improper installation.
STEP 4
Test fit the Right Accent to the Right saddlebag lid. It will center
on the front of the lid. PIC 3 There is a lip on the edge of the
Accent that will catch the bottom edge of the saddlebag lid.
PIC 4 Make any reference marks with masking tape or a
non–permanent
marker.
The adhesive will not bond correctly if applied at
temperatures less than 50°F. Do not attempt this
installation in temperatures less than 50°F.
STEP 5
Rub the backing of the adhesive with your fingernail to activate
the adhesive. Remove the backing. Using any reference marks
made in Step 4, attach the Accent to the right saddlebag lid.
PIC 4 Press in place for one minute. Full bonding will occur in
24
hours.
NOTE:
If the motorcycle is to be operated before the 24 hour
cure time has expired, use a good quality masking or
painter’s tape over the Accent to assist in holding the
Accent in place until the cure time is over.
STEP 6
Repeat Steps 4 and 5 for the left side.
Ride On!
SADDLEBAG FRONT KICK ACCENTS
INSTALLATION
THOROUGHLY CLEAN
THIS AREA ON BOTH
SADDLEBAGS
PIC 2
PIC 3
PIC 4
CENTER THE BOTTOM OF
THE ACCENT ON THE LID
LIP ON ACCENT FITS TO
BOTTOM EDGE OF LID