Ride on, L.e.d. lamps for 5000 series lights, Installation – Kuryakyn 5035 L.E.D. LAMPS for KURYAKYN 5000 SERIES LIGHTS User Manual

Page 2

Advertising
background image

PAGE

2


STEP 4

Remove the light bezel by twisting the bezel counter clockwise and pulling the bezel outward.

PIC 1


NOTE:

PIC 2 is an exploded view for reference.


STEP 5

Remove the rubber inner seal from the chrome light housing. The

glass light housing should now be free.


STEP 6

Pull the glass housing out away from the chrome housing and

disconnect

the

wires

PIC

3.

STEP 7

Remove the locating ring from the back of the glass light housing and

place it on the back of one of the new L.E.D. Lamps in the same

orientation. PIC 4 The notch on the locating ring goes on the bottom of the light

and will line up with a post on the bottom of the housing. PIC 5


NOTE:

Please note the orientation of the locating ring. This will greatly help

when reassembling the lights. PIC 4 and PIC 5

STEP 8

With the locating ring installed, connect the white wire from the new L.E.D. Lamp

to the white wire inside the lamp. Connect the black wire from the new L.E.D.

Lamp to the black wire inside the housing. Make sure the metal portion of both

connectors

are

fully

inside

the plastic insulating sleeve.

STEP 9

Place the new L.E.D. Lamp with the locating ring installed, into the light housing.

Place the rubber gasket into the chrome bezel (there is a cutout on the rubber

gasket that fits around the screw boss on the bezel PIC 6).

STEP 10

Line up the posts on the bezel with the notches on the housing and place the

bezel over the light and onto the housing. PIC 7 Turn the bezel clockwise to lock it

on and line up the threads in the bottom hole on the bezel. PIC 8

STEP 11

Insert the button head fastener removed in Step 3 and tighten securely. PIC 8

STEP 12

Repeat Steps 3 through 11 for the other light.

STEP 13

Reconnect the battery, turn the motorcycle on and test the lights.

ENSURE PROPER LIGHT OPERATION BEFORE RIDING THE

MOTORCYCLE. VISIBILITY IS A MAJOR CONCERN FOR

MOTORCYCLISTS. A LIGHT MALFUNCTION COULD RESULT IN

DEATH OR SERIOUS INJURY.

It is the installer’s responsibility to ensure that all of the fasteners
(including preassembled) are tightened before operation of the
motorcycle. Küryakyn will not warranty components lost due to

improper installation. Periodic maintenance may be required.




Ride On!

L.E.D. LAMPS for 5000 SERIES LIGHTS

INSTALLATION

UNPLUG THESE

PIC 3

PIC 2

PIC 4

PIC 5

PIC 6

PIC 7

PIC 8

BOX IS ON
THE TOP

OF LAMP

NOTCH ON
LOCATING

RING TO
BOTTOM

OF LAMP

NOTCH ON
LOCATING RING

FITS OVER POST
IN HOUSING

NOTCH IN RUBBER
GASKET FITS OVER

SCREW BOSS

POSTS ON BEZEL FIT INTO
NOTCHES ON HOUSING

ROTATE THIS DIRECTION TO INSTALL

INSTALL BUTTON FASTENER HERE

Advertising