Long lizard lights – Kuryakyn 5025 LONG Lizard Light User Manual
Page 2
INSTALLATION
NOTE:
This kit contains 2 Long Lizard Lights and wiring. A controller (p/n 4715) is required to
illuminate these lights, unless these lights are being used as an expansion to existing Super Lizard
Light Kits.
CAUTIONS
1 Do not operate more than 16 Seven-Color Super Lizard Lights on one controller. One Long
Lizard Light is equal to 2 Super Lizard Lights.
2 Seven Color Lizard Lights are designed for display or parade use. Check local regulations
regarding the use and placement of colored lights when the vehicle is operated on public streets.
3 To prevent corrosion, apply dielectric grease to all connections (including plugs).
4 Do not affix Seven Color Lizard Lights to hot engine or exhaust components.
5 The mounting surface must be perfectly clean for Lizard Lights to properly adhere. Remove wax,
dirt, dust, or any oily film with the alcohol pads provided before application.
STEP 2
Use your imagination! Determine what areas or features of the bike you wish to highlight.
Mark your desired locations with small pieces of masking tape. This will allow you to determine
if the supplied leads will be suitable for your plan. If you have a bike with a rubber mounted
engine, keep engine movement in mind. Do not mount Long Lizard Lights where the engine or
any related or moving components might contact the lights or wiring during normal operation.
Try to place plug connections in locations that will ease removal of the motorcycle’s components
as needed (i.e. fuel tank, horn). This will ease future service procedures.
STEP 3
Assemble the wiring and lights “on the bench” according to your plan. Use dielectric grease on
all connections. Make sure the red wire of each extension lead lines up with the red wire on Long Lizard
Light. Test the system to ensure the Long Lizard Lights illuminate and function before installation.
STEP 4
Using the supplied alcohol pads, thoroughly clean the mounting surfaces for the lights and the
switch. Wipe dry with a clean cloth.
STEP 5
Hide the mounting wires so they will not be visible. Nylon cable ties will be useful here.
PAGE
2
LONG LIzARD LIGhTS