Ride on, Taillight top trim for indian – Kuryakyn 7697 TAILLIGHT TOP TRIM for INDIAN User Manual
Page 2
Ride On!
MAKE ALIGNMENT
MARKS WITH TAPE
PRESS TRIM INTO PLACE
FOR ONE MINUTE
TRIM RESTS AGAINST
GASKET, NOT OVER IT
PIC 2
PAGE
2
TAILLIGHT TOP TRIM for INDIAN
INSTALLATION
STEP 3
Position the Taillight Trim as shown in PIC 2. Start at the top and work your way down the sides.
Note how the Trim rests against the rubber gasket, not over it. Use masking tape to make align-
ment marks. Remove the Trim.
.
STEP 4
Use your fingernail to rub the adhesive backing; this will activate the adhesive. Remove and dis-
card the backing.
STEP 5
Using the marks made in
STEP 3
, align the Trim and press it into place for one minute; full
bonding will occur after 24 hours. Remove and discard the masking tape.
NOTE:
If the bike is going to be operated before full bonding occurs, secure the
Trim to the fender with a good quality masking or painter’s tape.