Kuryakyn 6366 ISO GRIPS FOR INDIAN - Manual (Page 3)

PAGE
3
STEP 11 Test fit the ISO grip on the handlebar; determine the orientation of the grip before gluing it to the
handlebar.
STEP 12 Open the supplied tube of adhesive and squeeze all of the glue onto the inner side walls of the
clutch-side grip. Rotating the grip while applying the glue will help distribute it evenly. Make sure
you get the glue all the way to the end of the rubber insert in the grip.
STEP 13 In one smooth motion, slide the grip onto the handlebar and into position. Rotate it back and forth
slightly as you slide it on to help distribute the glue evenly and keep the grip from “plowing” the
glue up against the switch housing. You must work quickly to get the desired position be-
fore the glue dries. (Approx. 6 seconds).
STEP 14 Once in place, squeeze the grip firmly to press the rubber against the bar and hold for 15 seconds.
Allow at least 30 minutes to cure before operating the motorcycle.
STEP 15
Reinstall the main fuse. Ensure proper throttle and brake function BEFORE operating the
motorcycle.
ISO GRIPS FOR INDIAN
Ride On!
INSTALLATION
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.
Avoid contact with eyes, skin and clothing. Avoid breathing vapors or mists of
this product. Wash thoroughly after handling. Avoid contact with fabric or pa-
per goods. Contact with these materials may cause rapid polymerization which
can generate smoke and strong irritating vapors, and cause thermal burns.