KV2 Audio ESM12 Installation of the protective covering for driver - Manual

ESM12
ESM12
Protective covering
KVV120097-00-03-0
1 - Removing the grill :
Remove the ESM12 grill, unscrew 10pcs
hexagon screws, size 2,5.
2 - Removing the horn screws :
Remove 8pcs hexagon screws, size 3.
3 - Asembling the protective cover :
Place the protective cover over the driver
horn. Use hexagon screws dismantled
from the horn. Tighten the screws.
4 - Asembling the grill:
Place the grill and tighten the screws.
The ESM12 as true stage floor monitors come fitted with extra –heavy duty grills for protection from
standing and jumping by performing musicians and are built and designed for a tough and heavy
duty operation.
Similarly, to help protect the HF diaphragm component from liquids and excessive dirt ingress, both
units come supplied with an optional use- specially formed barrier protection, which can be fitted
over the HF Horn template by first removing the Horn screws and placing the plate over the horn.
This consists of a metal square frame that holds tensioned acoustical open gauze, which does not
allow liquid to pass through, but rather to run downwards into the bottom edge of the enclosure,
thus protecting the HF component.
The ESM26 and ESM12 do not come fitted with this frame from the factory as it does make some
slight difference to HF delivery and performance, thus we leave the choice for the operator to decide
on its employment.
Installation of the protective covering for driver