Tone and volume, Adjusting the bass, Adjusting the treble – Blaupunkt Alaska CJ70 User Manual
Page 11: Loudness, Adjusting the left/right volume balance, Adjusting the front/rear volume ratio (fader), Ta-sound
38
Tone and volume
Note:
You can make separate adjustments to the
bass, treble and loudness for each audio
source.
Adjusting the bass
➮
Press the AUD button,
9
.
“BASS” appears in the display.
➮
Press the or buttons,
7
, in order
to adjust the bass.
When you have finished the adjustment
➮
Press the AUD button,
9
.
Adjusting the treble
➮
Press the AUD button,
9
.
“BASS” appears in the display.
➮
Press the or button,
7
, as often
as is necessary for “TREBLE” to appear
in the display.
➮
Press the or buttons,
7
, in order
to adjust the treble.
When you have finished the adjustment
➮
Press the AUD button,
9
.
Loudness
Loudness refers to a bass boost at low vol-
ume levels matching the ear’s sensitivity.
➮
Press the AUD button,
9
.
“BASS” appears in the display.
➮
Press the or button,
7
, as often
as is necessary for “LOUD” to appear in
the display.
➮
Press the or buttons,
7
, in order
to adjust the loudness. “LOUD OFF”
means that the loudness function is in-
active, while “LOUD 6” indicates the
maximum loudness boost.
When you have finished the adjustment
➮
Press the AUD button,
9
.
Adjusting the left/right volume
balance
➮
In order to adjust the balance, press the
AUD button,
9
.
“BASS” appears in the display.
➮
Press the or button,
7
, as often
as is necessary for “BAL” to appear in
the display.
➮
Press the or buttons,
7
, in order
to adjust the balance between left and
right.
When you have finished the adjustment
➮
Press the AUD button,
9
.
Adjusting the front/rear volume
ratio (fader)
➮
In order to adjust the fader, press the
AUD button,
9
.
“BASS” appears in the display.
➮
Press the or button,
7
, as often
as is necessary for “FADER” to appear
in the display.
➮
Press the or buttons,
7
, in order
to adjust the balance between front and
rear.
When you have finished the adjustment
➮
Press the AUD button,
9
.
TA-SOUND
You can make separate adjustments to the
tone and volume for traffic announcements.
➮
Hold down the softkey,
4
, indicating
“TA” for longer than two seconds.
“TA-SOUND” appears in the display.
➮
Press the or button,
7
, as often
as is necessary for the desired parame-
ter to appear in the display.
➮
Perform the adjustments using the
or key,
7
.
When you have finished the adjustment
➮
Press the AUD button,
9
.
TONE AND VOLUME