Labnet 222DS Benchtop Shaking Incubator Quick Start Guide - Manual (Page 2)

222DS BENCHTOP SHAKING INCUBATOR Quick Guide
Page 2
2.
CHANGING PARAMETERS DURING OPERATION
Note: You can not modify time during operation.
 If you want to change Temperature during operation, press and hold encoder
knob for more than 2 sec. Temperature signal light blinks. Rotate encoder
clockwise (+) or counter-clockwise (-), to set the desired value. In the
meantime, temperature signal light pulses. When you set the new value,
press START/STOP key only ONCE. Shaking incubator goes back to
working parameters.
 If you want to change Speed during operation, press and hold encoder knob
for more than 2 sec. If shaking incubator is not set on speed (speed signal
light is not blinking), press encoder - speed signal light must blink. Rotate
encoder clockwise (+) or counter-clockwise (-), to set the desired value. In the
meantime speed signal light pulses. When you set new value, press
START/STOP key only ONCE. Shaking incubator goes back to working
parameters.
 When time elapses or you press START/STOP key again, message End
appears on display and Run signal light pulses. When shaking incubator
completely stops, it places itself to last used values for Time, Speed and
Temperature.
If you lift the lid during operation, shaking incubator stops
immediately and message Opn Lid appears on displays. When you
close the lid again, shaking incubator starts operating
automatically.
If there is a power cut during operation, shaking incubator will
restart automatically, as soon as the electricity returns. Display will
be flashing (warning you that the power was cut). You can turn the
flashing off, by pressing the encoder knob.
3.
SHAKING WITHOUT HEATING
 If you want to shake the samples without heating them, set Temperature to
OFF.
4.
HEATING WITHOUT SHAKING
 If you want to heat the samples without shaking them, set Speed to OFF.