Blaupunkt MP54 - Manual (Page 13)

13
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
Selecting the waveband /
memory bank
Selecting the waveband / memory bank
You can use this device to receive pro-
grammes broadcast over the FM and
AM wavebands. There are three mem-
ory banks (FM1, FM2 and FMT) for the
FM waveband and two memory banks
(AM and AMT) for the AM waveband.
Six stations can be stored in each mem-
ory bank.
To switch between the FM1, FM2 and
FMT memory banks,
➮
briefly press the FM•TS button
4
.
To switch between the AM and AMT
memory banks,
➮
briefly press the AM button
=
.
Tuning into a station
There are various ways of tuning into a
station.
Automatic station seek tuning
➮
Press the or button
7
.
The radio tunes into the next receiva-
ble station.
Tuning into stations manually
You can also tune into stations manual-
ly.
Note:
●
You can only tune into stations
manually if the RDS function is de-
activated.
➮
Press the or button
7
.
Setting the sensitivity of station
seek tuning
You can choose whether the radio
should only tune into stations providing
good reception or whether it can also
tune into those with a weak reception.
➮
Press the MENU button
9
.
“TUNER MENU” appears in the display.
➮
Press the OK button
:
to display
the tuner menu.
➮
Press the or button
7
repeat-
edly until “SENS” appears in the
display.
The display shows the currently set sen-
sitivity level. “SENS HI3” means that the
tuner is set to the highest sensitivity
setting. “SENS LO1” means it is set to
the lowest sensitivity setting.
➮
Set the sensitivity level that you
want using the
buttons
7
.
When you have finished making your
changes,
➮
press the MENU button
9
.
Note:
●
You can set different sensitivity lev-
els for FM and AM.
RADIO MODE