Bosch 5412L - Manual (Page 10)

10.
Disconnect plug from power source before performing any assembly, adjustment or repair to
avoid possible injury.
Assembly
Tools Needed For Assembly And Alignment
Should be no Gap or Overlap
when Square is Flipped Over in
Dotted Position
Draw Light
Line on Board
Along this Edge
Hex “L” Wrench
(supplied) 1.5mm
Straight Edge of
Board 3/4" Thick
This Edge Must be
Perfectly Straight
Multi Purpose Tool
(supplied)
Combination Square Must be True
Combination Square
10mm/17mm Combination
Open End Wrench
Before moving the saw: Lock the
miter lock knob in 45° position. Lock
bevel lock handle. Pull the head assembly complete-
ly toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may
cause blade damage.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connections
could cause a fire.
Model 4412 Miter Saw is shipped complete in one
box.
1. Separate all parts from packing materials and
check each one with the “Table of Loose Parts” to
make sure all items are accounted for before dis-
carding any packing material.
2. Table of Loose Parts:
Quick- Action Clamp - Used to clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Multi Purpose Tool - Should be stored on the right
rear base.
Rear Cord Wrap, washer and Screw - Used for
wrapping the cord
Miter Lock Knob - Used to lock the table at desired
miter angle.
Arbor Laser / 3x Battery / Arbor Laser Manual
If any parts are missing, do not plug
in power cord or turn the switch on
until the missing parts are obtained and are installed
correctly.
Attaching Miter Lock Knob
Locate the miter gauge lock knob from among the
loose parts, and thread shaft on lock knob into hole pro-
vided.
Attaching Rear Cord Wrap
Locate the rear cord wrap from among the loose parts,
position rear cord wrap as shown and secure with
washer and phillips screw provided.
WARNING !
WARNING ! WARNING !
Unpacking And Checking Contents
UNLOC
K
LOCK
Rear Cord Wrap
Phillips Screw
Washer
Miter Gauge
Lock Knob