Barco Coronis Fusion MDCC 6130 - Manual (Page 50)

Driver and Software Installation
50
Driver and Software Installation
This chapter will guide you through the installation of the drivers,
software and documentation associated with your Barco Coronis
Fusion 6MP Display System or Barco Coronis Fusion 6MP Display(s).
Driver and software installation prerequisites
Note: To install or remove the drivers, software, or
documentation you must be logged on as a user with
administrator privileges.
Your operating system must be installed and running before you can
install the driver, software and documentation for the Barco display
controller(s) for your B
ARCO C ORONIS F USION 6MP Display System.
Before you begin make sure that all of your Barco Coronis Fusion 6MP
Display(s) is connected to the appropriate display controller(s) in your
system.
Note: This installation procedure is based on operating
Windows in “Classic” theme. If “Aero” or “Basic” theme is
selected in Windows, sections of this procedure may be different
than what is listed.
Installing the B
ARCO
MXRT drivers and software
Note: The installation dialog will display in English if your
operating system’s language is not supported.
This process applies to the following versions of Windows:
• Windows 7 32 & 64 Bit
You will need to install the Barco Coronis Fusion 6MP Display system
drivers and software in the following cases: