Longevity PROMTS 200 - Manual (Page 18)

ProMTS 200 200AMP Synergic MIG/TIG/STICK
- 18 -
the wire diameter key to choose the manual mode. SPL state is manual mode,
the wire feed speed and welding voltage is adjusted separately.
Note：The current display is the wire feed speed (cm/min).
3. Adjusting Welding parameters
1) Different wire diameter, the minimum welding current is different；
2) Adjust the current knob; the corresponding welding voltage is changed automatically；
3) When the programmable welding voltage isn’t the perfect for the operator, the voltage
can be changed tinily by adjusted the knob；
4) If the operator adjusts the wave control knob, the arc characteristics can be controlled；
Note：With the ProMTS200, the burn back time is adjusted by the burn back knob under
the wire feed mechanism.
TIG mode operation:
1. Press the Welding Process Selection button, choose TIG process；
2. Press the welding mode key, choose 2T or 4T；
3. Adjust the current knob to control the welding current；
4. Adjust the down slope knob to control the welding current descend time.
STICK mode operation:
1. Press the Welding Process Selection button, choose STICK process
2. Adjust the current knob to control the welding current；
3. Adjust the welding arc force knob to control the arc force current.
Note：The current display is preset current before welding and is welding current when
welding. The voltage display is real voltage.