Bissell 94E9 - Manual (Page 8)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
8
Before you clean
Thoroughly sweep or vacuum floor
prior to cleaning with the Steam Mop
Select.
Cleaning hard floors
Your Steam Mop Select is designed to
clean hard flooring such as ceramic
tile, vinyl, laminate, marble, stone and
sealed hard wood floors. Use of your
Steam Mop Select on waxed or some
unwaxed floors may result in a dimin-
ished glossiness. The Steam Mop Select
is not for use on unsealed wood floors.
For best results test in an inconspicu-
ous area and check the care instructions
from your flooring manufacturer.
1. Plug the unit in and wait 30 seconds for it to
heat up. Begin cleaning by slowly passing
over surface while pressing the steam on
demand trigger to emit steam as needed.
2. To sanitize an area of your floor, (attack
invisible germs and bacteria) place the
Steam Mop Select over the spot for a
minimum 15 seconds using continuous
steam, but no longer than 20 seconds
using continuous steam. For larger areas,
overlap swivel head placement.
3. When the Steam Mop Select stops emitting
steam, unplug the unit. Simply remove the
water tank, refill, and continue cleaning.
WARNING:
Never put descaling, alcoholic,
or detergent products into the steam
cleaner, as this may damage it or
make it unsafe for use. Only use
BISSELL authorized aromatic
products