Marshalltown 59027 Mixer - Manual (Page 8)

7
5-SET-UP AND ASSEMBLY
This mixer is shipped partially disassembled and requires assembling.
1. Remove five ¼-20 x ½ hex hd. Cap screws, lock washers and hex nuts that secure
cover to the belt guard. Remove cover. (Save all hardware)
INSTALL MOTOR KIT PER INSTRUCTIONS
2. Replace the cover removed in step 1 and secure with hardware (saved). Tighten
securely.
3. Bolt the tilt wheel assembly to the tilt pinion. Tighten the set screw securely.
4. Although the mixer was lubricated at the factory, now is the perfect time to
become familiar with points requiring regular service. Refer to the
LUBRICATION AND STORAGE section.
5. All nuts and cap screws should be checked and tightened during the first two
hours of use. Periodic checks should be made thereafter.