Marshalltown 59000D Wheelbarrow Mixer - Manual (Page 12)

HOW TO MIX CONCRETE
Wheelbarrow Mixer - Model MIX59000D
You’ll need approximately 1 ¼ gallons of water.
1 – 80 lb. Bag of pre-mix concrete
1. Start Mixer
2. Put in 1 gallon of water
3. Add ½ of 80 lb. Bag of pre-mix concrete – mixture will be very sloppy
4. Slowly add 2nd half bag of concrete
5. Add ¼ gallon of water slowly to obtain desired thickness.
How to mix Sand & Gravel
Wheelbarrow Mixer - Model 59000D
You’ll need a square point shovel
Portland cement, gravel or round stone and masonry sand.
1. Start Mixer
2. Put in 1 gallon of water *
3. Add 3 shovels full of gravel or round stone
4. Add 1 shovel full of Portland cement
5. Add 2 shovels full of masonry sand – slowly
6. Add water to obtain desired thickness
* Amount of water will vary according to moisture content of sand and gravel.
Remember to grease fittings before every use!