Marshalltown SG87SH SURFACE SHARK Floor Grinder - Manual (Page 17)

SG87Sh SuRFACE ShARK FLooR GRINDER PAGE 17
FIGuRE 8
3) Mount the multi-accessory attachment into the slots
provided in the multi-accessory disc. If the attachment
is directional in design, determine that its mounting
position in the disc allows for proper operation.
4) Force Part# WEDGE Mounting Wedge into the area
between the multi-accessory attachment and the inside
rib of the aluminum disc by hand. The straight side of
the mounting wedge contacts the multi-accessory
attachment. The angled side of the mounting wedge
contacts the rib of the disc. FIGuRE 9. An improper
mounting configuration is depicted in FIGURE 10.
FIGuRE 9
FIGuRE 10
DO NOT OPERATE THE FLOOR GRINDER WITH
THE PART# WEDGE MOUNTING WEDGES IN
AN IMPROPER MOUNTING CONFIGURATION.
MOUNTING A WEDGE BETWEEN THE MULTI-
ACCESSORY ATTACHMENT AND THE OUTSIDE
RIB OF THE ALUMINUM DISC CAN ALLOW THE
WEDGE TO COME IN DIRECT CONTACT WITH A
VERTICAL WALL AND/OR FLOOR OBSTRUCTION.
SUCH OCCURRENCE CAN RESULT IN LOSS OF
MACHINE CONTROL, PROPERTY DAMAGE AND/
OR PERSONAL INJURY.
BEFORE OPERATING THE FLOOR GRINDER
WITH ANY MULTI-ACCESSORY ATTACHMENT,
DETERMINE THAT NO PORTION OF THE
ATTACHMENT AND/OR MOUNTING WEDGE
EXTENDS BEYOND THE NORMAL PERIMETER OF
THE ALUMINUM DISC.
5) using the hammer, strike the wider side of the
mounting wedge with controlled, direct blows to firmly
seat the multi-accessory attachment into the aluminum
disc. usually one or two direct blows will be sufficient
to properly retain the attachment.
Do not apply excessive impact force to the mounting
wedge to cause splitting. Once the multi-accessory
attachment is seated in the aluminum disc, further
impact force on the wedge will not increase the
seating force.