MARVEL Scientific 17CAF - Manual (Page 4)

INSTALLATION
WARNING
Electrical Information
• The power cord of the appliance is equipped with a three-
prong grounding plug for protection against shock hazards
(see Figure 3 below). It must be plugged directly into its own
properly grounded three-prong receptacle, protected with
a 15 amp time delay fuse or circuit breaker. The receptacle
must be installed in accordance with the local codes and or-
dinances. Consult a qualified electrician. Receptacles pro-
tected by Ground Fault Circuit Interrupters (GFCI) are NOT
RECOMMENDED. DO NOT use an extension cord or adapter
plug.
• If voltage varies by 10 percent or more, freezer performance
may be affected. Operating the freezer with insufficient pow-
er can damage the motor. Such damage is not covered under
the warranty. If you suspect your voltage is high or low, con-
sult your power company for testing.
• To prevent the freezer from being turned off accidentally, do
not plug the unit into an outlet controlled by a wall switch or
pull cord.
• Do not pinch, knot, or bend power cord in any manner.
Before starting the freezer, follow these important steps:
Installation
• Choose a place that is near a grounded electrical outlet.
• The freezer should be located where surrounding tempera-
tures will not exceed 110 degrees F (43 degrees C). Tempera-
tures of 32 degrees F (0 degrees C) and below will NOT affect
freezer operation. Additional compressor heaters are not
recommended.
• Allow space around the unit for good air circulation. Leave a
three (3) inch (75 millimeter) space on all sides of the freezer
for adequate circulation.
Leveling
The freezer must have all bottom corners resting firmly on a solid
floor. The floor must be strong enough to support a fully loaded
freezer. NOTE: It is VERY IMPORTANT for your freezer to be level
in order to function properly. If the freezer is not leveled dur-
ing installation, the door may be misaligned and not close or seal
properly, causing cooling, frost, or moisture problems.
To Level Unit (see Figure 4 below)
After discarding crating screws and wood base, use a carpenter’s
level to level the freezer from front-to-back. Adjust the plastic
leveling feet in front, 1/2 bubble higher, so that the door closes
easily when left halfway open.
Figure 3
Figure 4
WARNING
Other Precautions
• To defrost freezer, always unplug the freezer first.
• Never unplug the freezer by pulling on the power cord. Al-
ways grip the plug firmly and pull straight out from the re-
ceptacle.
• Turning the control to OFF turns off the compressor, but does
not disconnect power to other electrical components.
4