Mayline Ranger Split-Top - Manual (Page 3)

FRONT
Tab toward front edge
FRONT of TABLE
7. Attach the Upper Hinges (E2) to the underside of
the Tilt Top with #10 x 3/4 Particle Board Screws
(E8). Position with the hinge tab toward the front
edge of the top.
8. Attach Lift Assembly (E10) to the 'H' Frame cross
rail with #10-32 x 1/2 Flat Head Screws (E11).
9. Install the Tilt Top onto the table. Insert the
upper hinge tab into the slot of the lower hinge.
Raise the Lift Assembly and align the holes in the lift
with the holes in the top. Attach with #10 x 3/4
Particle Board Screws (E8).
10. Attach the Reference Top to the base with #10 x
3/4 Particle Board Screws (E8) through the front and
rear rail and through the side flange.
11. Attach Dust Cover (6) to base with #8 x 5/8
Screws (E7).
12. Attach top Bumpers (E9) to Dust Cover with #10
x 3/4 Screw (E8). Position approximately as show.
Measured from edge of dust cover.
FRONT of TABLE
(3)