Mayline CS Worktables - Manual (Page 2)

(2)
Assembly:
1. Begin assembly by placing the Laminated Top (1) upside down on a clean flat worksurface.
2. Locate and position the Universal Leg Assemblies (2). Secure by inserting and starting Screws (E1) through
the Leg assembly into the inserts installed in the Top. NOTE: Do Not tighten at this time.
NOTE: Universal Leg Assemblies (2) can be changed from right hand to left hand by removing the metal
inserts and installing them in the reverse position. See Fig. #1 To remove insert, slide the insert to the top of
the leg, rotate the bottom out, removing the tab from the cut out in the leg rail, then slide the top of the insert
from the top leg rail. Install in reverse order.
3. Attach the Modesty Panel (3) to the Universal Leg Assembly (2) with four Screws (E1). Secure the Modesty
Panel (3) to the Top (1) Using four Screws (E2). Tighten these screws first, then tighten all remaining screws.
4. Install the Floor Glides (E3) in the Leg Frames by inserting the threaded stud into the plastic sockets and
rotating clockwise.