Mayline Acrylic Panels - Manual (Page 4)

1. Attach Clamp Assemblies (2) to each end of the
Acrylic Panel (1) at notch by sliding panel into Clamp
Assembly (2) and tightening screws.
Next steps vary depending on location of panel.
For table end location:
2. Attach center Clamp Assembly (2) to table beam
using screws (E1). Note: Clamp Assembly screws
may need to be loosened to allow for screw to fit into
Clamp assembly and attach to the beam.
3. Slide Acrylic Panel (1) into Clamps (2).
4. Secure panel by tightening clamp screws.
For table seam location:
2. Attach center Clamp Assembly (2) to Offset Plate
(3) using Screw (E3) and Nut (E4). Note: Clamp
Assembly screws may need to be loosened to allow for
screw to fit into Clamp assembly and attach to the
beam.
3. Attach Clamp and Plate assembly to table beam
using Screw (E2).
3. Slide Acrylic Panel (1) into Clamps (2).
4. Secure panel by tightening clamp screws.
(4)