Mayline 10' Basic Conference Table - Manual (Page 2)

1. Install threaded inserts (E1) into legs (1).
2. Thread glides (E2) into threaded inserts installed in Step 1.
3. Thread glides (E3) into bottom of panel assembly (2).
4. Attach legs (1) to panel assembly (2) with screws (E4).
5. Partially install screws (E4) into the second hole from the top
and the bottom holes of each leg panel assembly so that the screw
heads are approximately 1/8" from the leg.
6.
Using the slots in the ends of the side panels (3), attach side
panels to leg assemblies. TIGHTEN ALL SCREWS AT THIS TIME.
(2)
Top hole
remains OPEN