Mayline 6' Basic Table Adder User Manual
Page 3
8.
Position Starter Worksurface over Starter Base and
loosely fasten in place using hardware and instructions
supplied with that product. Position Adder Worksurface (3)
on Adder Base and loosely fasten using Screws (E4)
through leg and side panels.
(3)
10.
Install Slam Latch (E5) into Leg Panel (4) cutout as
shown.
11.
Insert Leg Panel (4) into Adder Leg slots. Rotate Leg
Panel till slam latches catch.
5.
Assemble Starter Base per instructions included with that product.
6.
Move assembled Adder Base into position. Using the key hole slots in
the ends of the Modesty Panels (2), attach the Panels to the assembled
Starter Base. TIGHTEN FOUR SCREWS holding panels at this time.
7.
Continue the Conference Table assembly by joining another Adder
Base or complete the Conference Table by joining the final section.
9.
Continue the Conference Table assembly by
installing another Adder worksurface or complete the
Conference Table by installing the final worksurface.
Once ALL tops are installed and aligned, tighten all
screws.
Starter Base
Starter Worksurface
Starter Base