MEElectronics Air-Fi Metro AF71 - Manual (Page 17)

14
Pairing with Bluetooth Devices
*** It is only necessary to pair your Metro once with each device ***
iPhone, iPad, and iPod Touch
On your iPhone/iPad/iPod Touch, go to Settings
Select Bluetooth (older devices or old versions of iOS, you
may need to select General first)
Make sure the Metro AF71 is off and within 1 meter of your
device
On your iPhone/iPad/iPod or Touch make sure Bluetooth
is turned on
Turn on the Metro by pressing the Multifunction button for
approximately 8 seconds, until the red and blue
LEDs flash in an alternating manner
(Note: The Metro will stay in pairing mode for 2 minutes.
If no devices pair within 2 minutes, the Metro will return to
standby mode automatically.)
Wait until you see “AF71” in the Devices section of the screen;
it should show “Not Paired” as the status
Tap on “AF71” to pair and connect your iPhone/iPad/iPod
Touch to the Metro
The Metro will beep twice upon pairing and connection and
“AF71” should show “connected” on your device;
the blue LED on the Metro will flash twice every 4 seconds to
indicate a connection
If pairing fails, please repeat steps c) through g) above
a)
b)
c)
d)
e)
f)
g)
h)