Metal Sales Snap-Loc 24 Installation - Manual (Page 18)

SNAP-LOC 24
© Metal Sales Manufacturing Corporation / Subject to change without notice. 10/99
17
SELECTION OF SYSTEM COMPONENTS
LOW
HIGH
4" TO 6" BLANKET
4" TO 6" BLANKET
1 /
4
" LOW
1 1 /
4
" HIGH
3 1 /
8
" LOW
4 1 /
8
" HIGH
SYSTEM COMPONENTS
3 1 /
4
" LOW
4 1 /
4
" HIGH
FLOATING CLIP
BASE
VERTICAL TAB
DESIGN / INSTALLATION CONSIDERATIONS
(CONT.)
The following chart should be used to determine proper fasteners required for clip installation on the
selected applications. See Fastener Selection Guide pages 11, 12 for other fasteners available.
APPLICATION TYPE OF FASTENER NUMBER OF FASTENERS REQUIRED
1 /
4
-14 X 1 1 /
2
" SD N/W
1 /
4
-14 X 1 1 /
2
" SD N/W
10 X 1" PANCAKE HEAD WOODSCREW
14 X 1 5 /
8
" DEKFAST
12-24 X 1 1 /
4
" SD N/W #4
12-24 X 1 1 / 4 " SD N/W #4
CLIP OVER RIGID
INSULATION / METAL DECK
DEKFAST #15* STANDARD
UL-90 (CONST. NO. 240)
STANDARD
STANDARD
STANDARD
UL-90 (CONST. NO. 240)
STANDARD
CLIP OVER BAR JOIST
CLIP OVER PURLINS (12 GA. MAX)
CLIP OVER WOOD FRAMING
CLIP OVER WOOD DECK
* Length of Dekfast will vary depending on the total thickness of the rigid insulation and metal deck.
The following information should be used to determine system components needed once insulation
size has been selected. Refer to Fastener Selection Guide on pages 11, 12 for proper fasteners required
for selected componenets.
SEAM-LOC 24 PANEL CLIPS
- The floating clip allows the roof surface (panels) to move independently of the roof substructure to
allow for thermal expansion and contraction. These clips are designed with a vertical tab that slides
along the base section of the clip. Clips are placed along the male leg of each panel prior to installing
adjacent panels. Design wind uplift requirements must be considered for proper clip spacing
- The fixed clip does not allow the roof surface (panels) to move independently of the roof substructure
allowing for thermal expansion and contraction. These clips are only recommended for buildings
designed with panel lengths less than 30'-0".
SYSTEM CLIP RAKE ANGLE EAVE PLATE THERMAL BLOCK INSULATION
1 FASTENERS
2 FASTENERS
2 FASTENERS
1 FASTENERS
1 FASTENERS
2 FASTENERS
1 FASTENERS -
-
-
-
-
-
-
NONE REQUIRED
1"
FIXED CLIP
BASE
VERTICAL TAB