MK Diamond ATS Stand User Manual
Page 20
ATS Stand (ATS Stand Part No. – 156426)
Revision 04/01, Effective Date: April 11, 2001
Page 20
ATS STAND
(Document Part Number 158474)
(Q)
Orient and install the ATS
Stand Support Plate as shown
ATS Stand
Support Plate
(P)
Locate the ATS Stand Support
Plate retaining tubes on the back
of the ATS Stand
Retaining
Tubes
Installation
Direction
(O)
Install the Water Pan
(P)
Setup Complete
(K)
Install one D Bracket and a Bolt
into the front, side, of the ATS
Stand as shown
(J)
Install one D Bracket and a Bolt
into the rear, side, of the ATS
Stand as shown
(L)
Verify the two left-side D Brackets
are installed correctly
(N)
Using a 9/16-wrench and socket,
tighten all Bolts
(M)
Install one Nylock nut on the
Bolt of each bracket
(Do not cross-thread the nut)
Nylock
nuts
(Q)
Ensure all bolts are
tight before placing the ATS Stand
in the transport position
Transport
Position
Fit bracket
over saw frame
Bracket
D
Install into rear hole
on left side of stand
Bracket
D
Install into front hole
on left side of stand
Fit bracket
over saw frame
Bracket
D
Rotate clockwise
to install
Rotate
clockwise
to tighten
Rotate
clockwise
to tighten
(R)
Tighten the ATS Stand Support
Plate retaining thumbscrews
as shown
Retaining
Thumbscrew