MK Diamond Sawtec SDG-103 - Manual (Page 14)

14
Attach hose to dust port.
SDG ASSEMBLY
GRINDING DISCS INSTALLATION
You need to install the grinding disc before operation of the SDG. Ensure the correct type of
grinding disc is selected for the type of material being ground. After a few minutes of grinding check
the wear on the grinding disc.
Tilt Grinder back Place Grinding Disc on
mounting plate, aligning
bolt holes
Insert the four bolts and
tighten
GRINDING
The floor grinders are designed to be used either wet or dry.
DRY GRINDING
This shroud system, when used in conjunction with an appropriate industrial vacuum unit, eliminates
dust loss during grinding. Attach hose to dust port.
NOTE: Ensure a suitable industrial vacuum is connected and that operator is wearing
suitable breathing respiratory equipment.
Place hose through support.
wET GRINDING
The floor grinder comes complete with a water connection for wet
grinding. This incorporates a ball valve allowing the operator to
regulate the water supply to obtain the best grinding results.