MTS FlexTest Models 200 - Manual (Page 178)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Model 494.45 8-Input A/D Converter Card
Mezzanine Cards 178
Model 494.45 8-Input A/D Card Connections
Analog input signals are typically routed to the A/D converter card through a
Model 494.75 8-Input BNC Transition Board. The two transition board
outputs (J11, J12) connect to the I/O carrier board RJ-50 connectors used
with the A/D Converter card slot (J3A and J3B).
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors.
The use of other RJ connector types (less than 10 pins or unshielded)
with the I/O carrier board can cause component damage.
Only use cables equipped with 10-pin, braided shielded, RJ-50 connectors
(with gray boot) with the I/O carrier board.
CAUTION
First
494.76
ANALOG
OUTPUT CH 1 - 8
Last
J11
J12
1
2 3
4 5 6
7 8
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
Model 494.75 8-Input
BNC Transition Board Model 494.40 I/O Carrier Board
Transition
Card Cage
VME Card Cage Analog
Input
Devices
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Input 8
Input 1-4
Input 5-8
494.45 8-Input
A/D
Mezzanine Card